![]() ZENCUT | WINDOWS XP | SIGNCUT | FLEXI 10 | ESPAÑOL ZENCUT DRIVER AND SETUP GUIDE
WINDOWS XP ![]() WARNING: DO NOT PLUG THE CUTTER VIA USB BEFORE INSTALLING THESE DRIVERS, YOU WILL BE ASKED TO CONNECT THE CUTTER IN LATER STEPS.
STEP 1: Download the cutter driver. * * * DOWNLOAD ZENCUT GREEN USB DRIVER * * * ![]() * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * DOWNLOAD ZENCUT BLACK USB DRIVER * * * ![]() * * * * * * * * * * * * * * * * * * * * * * * * * * * * STEP 2: Locate the file and double click to install. The following screen will appear for a few seconds. STEP 3: The USB & Printer Driver Install screen will be displayed, press Next.
NOTE: Installing driver files... Once completed, press Next.
NOTE: The following screen will display for a few seconds.
STEP 4: The driver installation is complete. Press Finish.
STEP 5: Connect your ZenCut to the power source and turn on. Load a vinyl roll, measure it to detect the material using the commands on the cutter screen.
USB PRINTER TYPE (Windows 32-bit or 64-bit) IMPORTANT: Before connecting the cutter to your computer, check if the Operating System version is 32-bit or 64-bit as there is a setting in the cutter called “USB Printer Type” that needs to be adjusted accordingly to your computer’s processor architecture.
STEP 6: The following steps should be performed in the Cutter:
STEP 7: Connect the ZenCut to the Computer via USB. Windows will detect and install the driver, give Windows about 2 minutes to do so.
STEP 8: Once the driver has been successfully installed you will see the following screen.
NOTE: After installing the driver, the Device Manager will display a new entry under Universal Serial Bus controllers named USB Printing Support.
STEP 9: Open the Device Manager to ensure the cutter driver has been installed. If not repeat Step 1.
To access Device Manager, use any of the following methods:
ZENCUT PRINTER IMPORTANT: Keep in mind that this cutter installs as a Printer and that can found in Printers and Faxes. Check if this printer is present.
To access Printers and Faxes use the following method:
STEP 10: Locate the ZenCut printer, right click it and select Properties.
STEP 11: Select the Ports tab and ensure that your printer matches the setting in the example below.
* * * * * * * CUTTING SOFTWARE SETUP AND INSTALLATION * * * * * * *
CLICK THE ICON FOR THE SOFTWARE YOU ARE USING TO CONTINUE SETUP |