PCUT | WINDOWS 7 | SIGNCUT | FLEXI 10 | SIGNBLAZER | ESPAÑOL
CUTTING SOFTWARE INSTALLATION
* * * * * ALREADY INSTALLED SIGNBLAZER? CLICK HERE FOR THE CUTTER SETUP INFORMATION * * * * *
STEP 1: Insert the SignBlazer Elements disc into your computer. The disc is located in the accessories box (small cardboard box).
IMPORTANT: If this disc is missing, SignBlazer Elements is available for download.
* * * * DOWNLOAD REQUIRED SOFTWARE * * * *
* * * * * * * * * * * * * * * * * * * * * * * * * * * *
STEP 2: The following screen will display when using the CD, select Run Autorun.exe.
STEP 3: Select Run Setup.
STEP 4: The Welcome to the SignBlazer setup screen will display, press Next.
STEP 5: Select Yes and press Next.
STEP 6: Select I accept the agreement and press Next (x6).
STEP 7: Select your cutter from the list. If your cutter is not listed, select the Copam CP-2500 and press Next.
STEP 8: Select the COM? (if known) and press Next. If the cutter’s COM number is unknown select COM1.
STEP 9: Leave Baud Rate as 9600 and press Next.
STEP 10: Leave all this settings as shown and press Next.
STEP 11: Press Install.
STEP 12: Press Finish.
STEP 13: Open SignBlazer Elements, and press the Trial Mode button.
STEP 14: Press the Cutter and Setup buttons.
STEP 15: Select the Cutter and Output Device matching the settings from the example below.
STEP 16: To cut press the Cutter and CUT! buttons, a window will open on the right side and press the Cut Tile button.
STEP 17: If you need more information about SignBlazer, download the User's Manual.