![]() MH SERIES | WINDOWS XP | SIGNCUT | FLEXI 10 | ESPAÑOL MH SERIES MK2 DRIVER AND SETUP GUIDE
FOR WINDOWS XP ![]() IMPORTANT: The Baud Rate in the cutter settings needs to be changed from 9600 to 4800. Turn on your cutter and follow the steps below.
STEP 1: Download the Cutter Driver onto your computer. * * * * DOWNLOAD REQUIRED USB DRIVER * * * * ![]() * * * * * * * * * * * * * * * * * * * * * * * * * * * * STEP 2: Locate the file MH_MK2 Driver (ex. Desktop, My Documents, Downloads) double click to run, and extract.
IMPORTANT: Is very important you know where is this file going to be saved in your computer. For this example, the file was saved to the Desktop. ![]() STEP 3: The following screen is a Security Warning, press Run.
![]() STEP 4: Press Extract. The file will be placed along with the MH-MK2 Driver.
![]() STEP 5: The extracted USCutter folder will then appear.
![]() STEP 6: Assuming that you already plugged the cutter via USB you need to access the Device Manager to access the Found New Hardware Wizard and install the driver.
To access Device Manager, use any of the following methods:
STEP 7: Locate Other Devices and double click on USCutter Series. ![]() STEP 8: The USCutter Series properties will display. Select the Driver tab and press the Update Driver button. ![]() STEP 9: The Found New Hardware Wizard will open, select Yes, this time only and press Next.
![]() STEP 10: Select Install from a list or specific location (Advanced) and then press Next.
![]() STEP 11: Place a check mark under Include this location in the search then press Browse.
![]() STEP 12: Search and select the USCutter folder that was extracted in Step 5 and press OK.
![]() STEP 13: The Found New Hardware Wizard will look for the driver. This might take a few minutes.
![]() STEP 14: The following message may appear during the driver installation, press Continue Anyway.
![]() NOTE: The Found New Hardware Wizard will copy the driver files.
![]() STEP 15: Once the driver has been successfully installed you will see the following screen. Press Finish.
![]() NOTE: The following message appears notifying that the driver was installed.
![]() USCUTTER SERIES PRINTER
IMPORTANT: After the driver installation, a new printer named USCutter Series can be found under Printers and Faxes.
![]() STEP 16: Go to Printers to check the USB port number assigned to the USCutter Series printer.
To access the Printers section, use the following method:
STEP 17: Locate the USCutter Series Printer, right click it and select Properties.
![]() STEP 18: Select the Ports tab and check the Port section to see what USB00? has been assigned to the cutter. The ? could be any number.
![]() NOTE: At this point remember what USB00? number has been assigned as it needs to match in SignBlazer Elements or Flexi cutting software.
* * * * * * * CUTTING SOFTWARE SETUP AND INSTALLATION * * * * * * *
CLICK THE ICON FOR THE SOFTWARE YOU ARE USING TO CONTINUE SETUP |