MH SERIES  |  WINDOWS 7  |  SIGNCUT  |  FLEXI 10  |  ESPAÑOL




MH SERIES MK2 DRIVER AND SETUP GUIDE
FOR WINDOWS 7




IMPORTANT: The Baud Rate in the cutter settings needs to be changed from 9600 to 4800. Turn on your cutter and follow the steps below.

  1. Press the Setup button once or twice and look for Baud Rate
  2. Press the left or right keys and change to 4800
  3. Press the Reset button

STEP 1: Download the Cutter Driver onto your Computer.


 * * * * DOWNLOAD REQUIRED USB DRIVER * * * *



* * * * * * * * * * * * * * * * * * * * * * * * * * * *

STEP 2: Locate the file MH_MK2 Driver (ex. Desktop, My Documents, Downloads) double click to run, and extract.

IMPORTANT: Is very important you know where is this file going to be saved in your computer. For this example, the file was saved to the Desktop.



STEP 3: The following screen is a Security Warning, press Run.



STEP 4: Press Extract. The file will be placed along with the MH-MK2 Driver.



STEP 5: The extracted USCutter folder will then appear.



STEP 6: Assuming that you already plugged the cutter via USB you need to access the Device Manager to access the Update Driver Software and install the driver.

To access the Device Manager, use any of the following methods:

  • Start > Run > and type: devmgmt.msc
  • Start > Control Panel > Device Manager or System
  • Start > and do a Search for Device Manager or dev
  • Start > Control Panel > System and Security > System > Device Manager
  • Hold the Windows key + Pause Break > Device Manager
  • Right-click My Computer > Properties > Device Manager

STEP 7: Locate Other Devices and double click on USCutter Series.



STEP 8: The USCutter Series properties will display. Select the Driver tab and press the Update Driver button.



STEP 9: Select Browse my computer for driver software.



STEP 10: Press the Browse button. Be sure to have the box next to “include subfolders”, checked.



STEP 11: Search and select the USCutter folder that was extracted in Step 5 and press OK.



STEP 12: Press Next.



STEP 13: The following message may appear during the driver installation, select Install this driver software anyway.



NOTE: Installing driver...



STEP 14: Once the driver has been successfully installed you will see the following screen. Press Close.



NOTE: The following message appears notifying that the driver was installed.




USCUTTER SERIES PRINTER

IMPORTANT: After the driver installation, a new printer named USCutter Series can be found under Devices and Printers.

STEP 15: Go to Devices and Printers to check the USB port number assigned to the USCutter Series printer.

To access the Devices and Printers, use any of the following methods:

  • Start > Printers
  • Start > Control Panel > Printers
  • Start > Run > and type: Control Printers
  • Start > Control Panel > Hardware and Sound > Printers

STEP 16: Locate the USCutter Series Printer, right click it and select Printer Properties.



STEP 17: Select the Ports tab and check the Port section to see what USB00? has been assigned to the cutter. The ? could be any number.



NOTE: At this point remember what USB00? number has been assigned as it needs to match in SignBlazer Elements or Flexi cutting software.


* * * * * * * CUTTING SOFTWARE SETUP AND INSTALLATION * * * * * * *
CLICK THE ICON FOR THE SOFTWARE YOU ARE USING TO CONTINUE SETUP





IMPORTANT: If you have had any problems with this guide and need help or if you would just like to send us feed back on this guide please click the Live Support icon to enter into a chat with our support staff.


Enjoy your new vinyl cutter! Thank you for choosing USCutter
Comments