LASERPOINT  |  WINDOWS VISTA  |  SIGNCUT  |  FLEXI 10    |  ESPAÑOL  




LASERPOINT DRIVER AND SETUP GUIDE
FOR WINDOWS VISTA




STEP 1: Download the Cutter Driver onto your Computer.


 * * * * DOWNLOAD REQUIRED USB DRIVER * * * *



* * * * * * * * * * * * * * * * * * * * * * * * * * * *

STEP 2: Locate the driver file and double click to run it.



NOTE: The following screen will appear for a few seconds.



STEP 3: Turn on the cutter and connect via USB. Windows will detect the device and installs the driver, wait about 2 minutes to do so.



STEP 4: Once the driver has been successfully installed you will see the following message.



NOTE: After installing the driver, the Device Manager will display a new entry called: Ports (COM & LPT) and under that: USB Serial Port (COM?). The ? is the COM Port number. It is important to know the COM Number assigned to the cutter as this needs to match with your cutting software.

STEP 5: Open the Device Manager and check under Ports (COM & LPT)

To access Device Manager, use any of the following methods
:

  • Start > Run > and type: devmgmt.msc
  • Start > Control Panel > Device Manager or System
  • Start > and do a Search for Device Manager or dev
  • Start > Control Panel > System and Security > System > Device Manager
  • Hold the Windows key + Pause Break > Device Manager
  • Right-click My Computer > Properties > Device Manager




* * * * * * * CUTTING SOFTWARE SETUP AND INSTALLATION * * * * * * *
CLICK THE ICON FOR THE SOFTWARE YOU ARE USING TO CONTINUE SETUP





IMPORTANT: If you have had any problems with this guide and need help or if you would just like to send us feed back on this guide please click the Live Support icon to enter into a chat with our support staff.


Enjoy your new vinyl cutter! Thank you for choosing USCutter