ZENCUT  |  WINDOWS XP  |  SIGNCUT  |  FLEXI 10  |  SIGNBLAZER  |  TROUBLESHOOTING




ALTERNATIVE INSTALLATION
DRIVER INSTALLATION FAILS AFTER CONNECTING THE CUTTER TO THE COMPUTER


NOTE: If the driver does not install or the installation fails, follow these steps:


STEP 1: Open the Device Manager.

To access Device Manager, use any of the following methods:
  1. Start > Run > and type: devmgmt.msc
  2. Start > Control Panel > Systems > Hardware tab > Device Manager
  3. Hold the Windows Key + Pause Break > Hardware tab > Device Manager
  4. Right click the My Computer icon and choose Properties > Hardware tab > Device Manager
STEP 2: Locate Other Devices and double click on USB-PRINTER.


STEP 3: The USB-PRINTER properties will display. Select the Driver tab and click the Update Driver button.


STEP 4: Select Yes, this time only and press Next.


STEP 5: Select Install the software automatically (Recommended) and press Next.


NOTE: Installing drivers...


STEP 6: The following message may appear during the driver installation, select Continue Anyway.


NOTE: Installing drivers...


STEP 7:
Cutter driver successfully installed, press Finish.


STEP 8: The updated properties will be displayed, select OK.


NOTE: Now follow Step 8 on the Cutting Software Guide.


* * * * * * * CUTTING SOFTWARE INSTALLATION AND SETUP * * * * * * *

CLICK THE ICON FOR THE SOFTWARE YOU ARE USING TO CONTINUE SETUP

 

 





Enjoy your new vinyl cutter!  Thank you for choosing USCutter