COPAM  |  WINDOWS 7  |  SIGNCUT  |  FLEXI 10  |  SIGNBLAZER  |  TROUBLESHOOTING




ALTERNATIVE INSTALLATION
DRIVER INSTALLATION FAILS AFTER CONNECTING THE CUTTER TO THE COMPUTER


NOTE: If the driver does not install or the installation fails after connecting the cutter via USB and power on, follow these steps:


STEP 1: Open the Device Manager.

To access Device Manager, use any of the following methods:
  1. Start > Control Panel > System and Security > System > Device Manager
  2. Start > Control Panel > Device Manager or System
  3. Start > Run > and type: devmgmt.msc
  4. Start > and do a Search for Device Manager or dev
  5. Right click the My Computer icon > Properties > Device Manager
  6. Hold the Windows key + Pause Break on your keyboard
STEP 2: Locate Other Devices and double click on USB Serial Port.


STEP 3: The USB Serial Port Properties will display. Select the Driver tab and click the Update Driver button.


STEP 4: The Update Driver Software will open, select Search automatically for updated driver software.


NOTE: The Update Driver Software will look for the driver. This might take a few minutes.


NOTE: The following message may appear during the driver installation, select Install this driver software anyway.


STEP 5: Once the driver has been successfully installed you will see the following screen. Press Close.


NOTE: The following message will display notifying that the driver was installed.


NOTE: This is how the device driver properties should look like after updating.


NOTE: This is how the device manager USB Serial Port properties should look like after updating.


NOTE: The next step is to install the Cutting Software.


* * * * * * * CUTTING SOFTWARE INSTALLATION AND SETUP * * * * * * *

CLICK THE ICON FOR THE SOFTWARE YOU ARE USING TO CONTINUE SETUP

 

 


 


Enjoy your new vinyl cutter!  Thank you for choosing USCutter

Comments